Illustration Photo Purifier SH2000


Contaminated oil is drawn into the purifier by the use of vacuum.

Before entering the reactor chamber the oil will be heated up to approximately 50°C (122°F). Extensive testing has shown this to be an ideal temperature for most hydraulic fluids, and allows maximum water extraction without destroying the physical properties of the fluid.
The temperature is adjustable both higher and lower to accommodate a wide variety of fluid properties. In addition, air is mixed into the hot oil, attracting the moisture entrapped in the oil when entering the reactor chamber. By exposing the water-contaminated oil to vacuum, the water and gas converts into saturated vapor, leaving the reactor column in the top area. The purified oil is then collected in the bottom and pumped back to the reservoir.


  • Two purifier technologies in one – higher water removal effectiveness
  • Removes 100 % free water and entrapped gases
  • Removes 90-99 % of dissolved emulsions
  • Addresses the root cause of particle formation
  • Less additives needed (anti corrosion, anti-foaming etc.)
  • Reduces down time
  • Prolonged life time of oil
  • Low maintenance cost
  • Easy installation – plug and play
  • Light-weight design
  • Portable and compact unit – low space and footprint needed
  • Extremely efficient in comparison to similar products

Maintaining a hydraulic system’s fluid cleanliness level will increase the life of the critical wear components, and reduce system downtime.

Feature Value
Circulation Flow Rate 10 l/min
Electrical Power Consumption 7500W
Frequency 50/60 Hz
Heater 6000W
Max Gross Weight 100 kg
Normal Operating Vacuum -0,9 bar
Operation Fluid Mineral Oil
Size of Reservoir
Temperatur Range 15-70°C
Viscosity 10-7700 cSt at 40°C
Voltage 380/440 V
Water Removal 100% free of water and gases, up to 95% of dissolved water and gases
Dimensions (L x B x H) 1040mm x 600mm x 400mm

Additional Information:

Removes 100 % free water and entrapped gases

Any Questions?

Contact us at any time, if you have questions regarding our products and services.

Contact us


Contact us

Phone: +47 56 12 67 00